Description
The Arisaka Indexer is a continuation of our low profile, minimal control accessories.
The Indexer can be used in a variety of ways, but the main intent is to place it between two fingers (usually index and middle). This typically places it further forward on the handguard, which also means it doesn't get in the way when transitioning to kneeling or prone shooting positions, where most people move their support hand towards the rear. Used in this manner, the Indexer makes it much easier to pull the rifle into your shoulder and maintain control while shooting.
Additionally, the wider, flatter profile of the Indexer functions very well as a hand stop or barricade stop, and also works as a forward limit to prevent your fingers from slipping off shorter handguards onto a hot barrel or suppressor.
LWRC
The Patent Pending Arisaka Indexer is a continuation of our low profile, minimal control accessories. It was developed due to end-user demand for a LWRC version to fit the proprietary LWRC threaded handguard, and features a slim front-to-back profile and slight radius across both faces.
Height: 1.0"
Width: 0.58"
Length: 1.8"
Weight: 0.8 oz
The Indexer is CNC machined from 6061-T651 aluminum and MIL-A-8625 Type III hard coat anodized. Requires an IP20 TorxPlus driver for installation (not included).
Hardware: Two 8-32x3/8" Torx flat head screws.
KeyMod
The Patent Pending Arisaka Indexer is a continuation of our low profile, minimal control accessories. It was developed due to end-user demand for a KeyMod version of our Finger Stop for Picatinny rails, and features a slim front-to-back profile and slight radius across both faces.
Height: 1.0"
Width: 0.58"
Length: 1.5"
Weight: 0.6 oz
The Indexer is CNC machined from 6061-T651 aluminum and MIL-A-8625 Type III hard coat anodized. Requires a T15 Torx wrench for installation (not included).
Hardware: Two BCM inverted KeyMod screws.
Geissele SMR 416
The Patent Pending Arisaka Indexer is a continuation of our low profile, minimal control accessories. It was developed due to end-user demand for a Geissele SMR 416 version of our Finger Stop for Picatinny rails, and features a slim front-to-back profile and slight radius across both faces.
Height: 1.0"
Width: 0.58"
Length: 2.2"
Weight: 0.9 oz
The Indexer is CNC machined from 6061-T651 aluminum and MIL-A-8625 Type III hard coat anodized. Requires an IP25 TorxPlus driver for installation (not included).
Hardware: Two 10-32x3/8" Torx flat head screws.
M-LOK
The Patent Pending Arisaka Indexer is a continuation of our low profile, minimal control accessories. It was developed due to end-user demand for an M-Lok version of our Finger Stop for Picatinny rails, and features a slim front-to-back profile and slight radius across both faces.
Height: 1.0"
Width: 0.58"
Length: 1.5"
Weight: 0.6 oz
The Indexer is CNC machined from 6061-T651 aluminum and MIL-A-8625 Type III hard coat anodized. Requires an IP20/T20 Torx wrench for installation (not included).
Hardware: Two M-Lok nuts and two 10-24x5/16" Torx button head screws.
Made in the USA.
